The process
The sinter strand draws air down through the burning bed with a large ID fan, the main exhauster, handling waste gas that is hot, dusty and acidic. Dedusting fans serve the cooler and the material handling, all on abrasive ore and flux fines.
The gas
Sinter strand waste gas carries ore and flux fines with acid components from the sulphur in the fuel. Wear and corrosion both act on the wheel; material and liner selection follow the gas analysis.
Selection for this process
| Type | Guillotine for isolation, multi louver or butterfly for control, diverter where the gas is switched between two paths |
| Material | SS 310 or SS 316 for gas above 300°C or corrosive |
| Sealing | Seal air arrangement where tight shut-off is needed on hot or dusty gas |
Types, construction and performance of the dampers.
Industries
Fans in sinter plants
Dampers in other processes
Waste Heat Recovery BoilersCement Preheater KilnsVertical Roller Raw MillsClinker Grate CoolersRotary Lime KilnsSponge Iron Rotary KilnsBlast Furnace Hot Blast StovesElectric Arc Furnace SteelmakingLadle Furnaces and Secondary MetallurgySteel Reheating FurnacesFerro Alloy Submerged Arc FurnacesCopper and Zinc SmeltingGlass Melting FurnacesCeramic Tunnel and Roller KilnsWaste IncineratorsRefinery Fired HeatersNuclear Facility VentilationBOF Steel ConvertersIron Ore Pellet Plants
Information needed to select or quote
- Gas volume and temperature. Actual flow at the inlet, normal and upset temperature, moisture.
- Dust or pollutant. Inlet loading, particle size distribution, whether it is abrasive, sticky, hygroscopic or combustible; for gases, the species and concentration.
- Required outlet. The emission limit or clean gas concentration the unit must meet.
- Site. Available space and height, material of construction preferences, and how the collected material is to be discharged.